How do I add devices to an existing Rocketboost network?

0
Started ‎09-13-2013 by
Modified ‎09-13-2013 by

Question

How do I add devices to an existing Rocketboost network?

Answer

You need to join both the wireless sender/receiver and the wireless speaker to your existing hub device, using the following steps:

  1. Set the HUB switch on the wireless sender/receiver to DISABLE.
  2. The power indicators turn green when the HUB switch is set to ENABLE.
  3. The power indicators turn blue when the HUB switch is set to DISABLE.
  4. Press and hold the POWER button on the your Rocketboost Hub device for more than three seconds to put it into joining mode. The power indicator starts blinking rapidly and the unit will stay in joining mode for 30 seconds.
  5. Press and hold the button on the wireless sender/receiver for more than three seconds, so the Hub device and wireless sender/receiver enter joining mode.
  6. The power indicators light steadily if the joining was successful.
  7. The power indicators blink slowly if the joining was not successful. Try steps 2 and 3 once again.
  8. NOTE: Rocketboost devices have their own memory. After the devices are joined once, they will remember each other and join automatically when your devices are powered on again. Because of this, you can join all of your network components in the same room before installing them in their permanent locations throughout the house.
Contributors