08-16-2013 11:40 AM - edited 08-16-2013 02:47 PM
If the wireless sender/receiver or wireless speaker indicator lights are flashing, the devices are not joined.
08-16-2013 11:40 AM
08-16-2013 11:44 AM
08-16-2013 11:48 AM - edited 08-16-2013 02:48 PM
The wireless sender/receiver and wireless speakers have been joined at the factory. Use these instructions if the devices failed to join, or if you need to re-join. After the devices are joined once, they will remember each other and join automatically when your devices are turned on again. Because of this, you can join all of your network components in the same room before installing them in their permanent locations. If you already have an existing Rocketfish network, see Question 14 for setup instructions.
To join your wireless speakers:
08-16-2013 12:09 PM - edited 08-16-2013 02:49 PM
Every Rocketboost network must contain one hub device, which helps devices join the network. After the devices are joined once, they will remember each other and join automatically when your devices are turned on again. Hub devices must always have power for your network to operate. The hub device can be in standby (power-saving) mode, but must stay plugged in.
To connect your wireless speakers to your existing Rocketboost network:
08-16-2013 02:28 PM
08-16-2013 02:29 PM
08-16-2013 02:31 PM - edited 08-16-2013 02:50 PM
08-16-2013 02:32 PM - edited 08-16-2013 02:50 PM